首页 » Mircrosoft » SCCM » How to restart a SCCM OSD Task Sequence within WinPE

How to restart a SCCM OSD Task Sequence within WinPE

作者: lesca 分类: SCCM, Tutorials 发布时间: 2017-07-23 20:07 ė浏览 94 次 6没有评论

Introduction

本文介绍如何在不重启的情况下,重新加载SCCM OSD任务序列(Task Sequence)
This article describes how to restart SCCM OSD task sequence within PE without restarting the computer.

Steps:

  1. del X:\SMS\data\variables.dat
  2. TsmBootstrap.exe /env:WinPE /configpath:x:\sms\data

Notes:

  1. 如果之前由于任务序列出错导致任务终止,需要先删除variables.dat文件,否则若直接执行第二部有可能无效。
    If the previous deployment is accidentally terminated, you should remove the variables.dat file before proceed the 2nd step; otherwise the 2nd step might not work as expected.
  2. 重启任务序列后,日志位于X:\Windows\temp\SMSTSLog\smsts.log
    After the tast sequence restarts, the log locates at: X:\Windows\temp\SMSTSLog\smsts.log

本文出自 Lesca技术宅,转载时请注明出处及相应链接。

本文永久链接: https://lesca.me/archives/how-to-restart-a-sccm-osd-task-sequence-within-winpe.html

0

Leave a Reply

Your email address will not be published. Required fields are marked *

Ɣ回顶部